Note:You are reading this message because your browser either doesn't support cascading style sheet (CSS) standards or is unable to access our CSS files (perhaps a browser setting). The majority of websites now use CSS to dramatically improve page layout. Virtually all recent browsers support CSS, so why not upgrade to view sites how they were intended to be seen?
ASSET InterTech is the world leader in Manufacturing Test and Hardware Debug Solutions for processor-based boards.
µMaster's Interactive mode of operation is useful in board development debug and New Product Introduction. Reads and writes can be made from and to any device registers at any location in the board's memory map. Bus tests, memory tests and dumps, flash programming, probe stimulus and many other tools are provided. There is also a BIOS Trace tool for boards driven by Intel® Pentium® processor families.
In Operator Mode, µMaster structural and functional testing is fully automated. µMaster's e-JTAG uses a combination of JTAG and CPU Emulation for structural testing. Functional testing is via CPU Emulation. Test results can be either PASS/FAIL or with full diagnostics. Test times are short, which means that in-line testing does not impact the line's beat rate.
µMaster is the ultimate tool for board debug. Even dead, non-booting boards are no problem for µMaster to diagnose. The built-in Guided Fault Isolation interface gives extensive guidance to operators and repair technicians. This whitepaper shows how dead boards are debugged.
